From: Kenneth Smith <ken.smith**At_Symbol_Here**UCOP.EDU>
Subject: FW: [DCHAS-L] [DCHAS-L] piranha solution
Date: Wed, 20 Aug 2014 16:47:07 +0000
Reply-To: DCHAS-L <DCHAS-L**At_Symbol_Here**MED.CORNELL.EDU>
Message-ID: BE98623C45B2C249BEA46E72FD99780926A3D28F**At_Symbol_Here**p-irc-exmbx02.AD.UCOP.EDU


From: Weizman, Haim [mailto:hweizman**At_Symbol_Here**]
Sent: Wednesday, August 20, 2014 8:55 AM
To: Kenneth Smith
Subject: Re: [DCHAS-L] piranha solution




I recall that this is the common practice (see Princeton's: My logical reasoning is : If decomposition of H2O2 occurs upon contact with acid then less acid will be splashed compare with the opposite direction. I think that most people see the H2O in H2O2  and therefore thinks that they need to be treated the same. I don't know if someone actually took the time to do a controlled experiment.




Haim Weizman, Ph.D.

Department of Chemistry and Biochemistry 0303

University of California, San Diego

La Jolla, CA, 92093-0303

Chemorphesis Project:





On Aug 20, 2014, at 7:23 AM, Kenneth Smith <ken.smith**At_Symbol_Here**>


Hi Wayne –


I came across this question previously. I too initially thought add A->W just like I was taught undergraduate chemistry. But turns out that this is not necessarily the preferred method in forming piranha solution.


If you take a t look at Time mark 6:17 or so you can see the instruction is to add peroxide to acid.


From what I recall from Dr. Haim Weizman this quick scene in the video generated a lot of questions. Reviewers of the video commented and questioned this as it seemed counter intuitive to them as well. If I recall there were some technical reasons, degree of reactivity, heat capacity of acid vs peroxide solution to do it in this sequence. The exact reason I cannot recall. I did remember that the degree of preference was only slightly better in this direction over the other and the take home message was hazard of heat generation was rapid and high so the reaction should always be done very carefully with good thermal cooling controls.


I’ve cc’ed Dr.. Weizman as he might be able to contribute more.





University of California

Interim Director of EH&S
Laboratory Safety Manager
voice (510) 882-3499


From: DCHAS-L Discussion List [mailto:dchas-l**At_Symbol_Here**MED.CORNELL.EDU] On Behalf Of James Saccardo
Sent: Tuesday, August 19, 2014 7:22 PM
Subject: Re: [DCHAS-L] piranha solution


Wayne, I say pour conc. acid into the peroxide allowing the acid to dissolve into the peroxide, thus allowing the ionizing acid to dilute into the entire volume of peroxide on contact. Pouring peroxide into the conc.acid would cause the peroxide to "spit" off the surface of the acid, as there will be pockets of conc. acid ionizing with smaller volumes of peroxide, without any medium to absorb the heat of solution.


Acid into water is what I was always taught for the reasoning above.


Sent from 4G LTE Smartphone


----- Reply message -----
From: "Wayne Phan" <
To: "
Subject: [DCHAS-L] piranha solution
Date: Tue, Aug 19, 2014 7:09 PM


When preparing piranha solution, do we add acid to the peroxide or the peroxide to the acid.  I see different opinions on this.  What is the standard practice?






CSI Represents NY in Nationwide State Rankings. Learn more>>>


Previous post   |  Top of Page   |   Next post

The content of this page reflects the personal opinion(s) of the author(s) only, not the American Chemical Society, ILPI, Safety Emporium, or any other party. Use of any information on this page is at the reader's own risk. Unauthorized reproduction of these materials is prohibited. Send questions/comments about the archive to
The maintenance and hosting of the DCHAS-L archive is provided through the generous support of Safety Emporium.