From: Monona Rossol <0000030664c37427-dmarc-request**At_Symbol_Here**LISTS.PRINCETON.EDU>
Subject: Re: [DCHAS-L] NIOSH Technical Report P/N 2021-107: Filtering Facepiece Respirators with an Exhalation Valve: Measurements of Filtration Efficiency to Evaluate Their Potential for Source Control
Date: Sat, 12 Dec 2020 12:08:31 +0000
Reply-To: Monona Rossol <actsnyc**At_Symbol_Here**CS.COM>
Message-ID: 1047329048.6057809.1607774911876**At_Symbol_Here**mail.yahoo.com
In-Reply-To


John,   Couldn't sleep.  I reread the report and wrote a summary of the info in preparation for a short newsletter article.  Thought it might be helpful to some CHASers.

Technical Report.  Filtering Facepiece Respirators with an Exhalation Valve: Measurements of Filtration Efficiency to Evaluate Their Potential for Source Control.  DHHS (NIOSH) Publication No. 2021-107

The study problem is clearly defined in three computer generated exhalation emission photographs:

1) A properly fitted filtering facepiece respirator (FFR) without an exhalation valve showed less than 5% of the particles escape on exhalation.  

2) The FFR with an exhalation valve allows 20% of the particles through the valve.

3) a barrier face covering without a good fit (seal to the face) releases 50% of the particles.

All types of FFRs and masks were tested at "moderate exercise" levels of 85 liters per minute (lpm) as specified in NIOSH certification tests.  Two lower breathing rates were also compared.  But the effects of a cough and sneeze were not investigated which limits this study.

Another study limit was the test method in which the FFRs and masks were sealed with beeswax to the inward and outward testing apparatus.  This eliminated the fit of the respirators as a factor.  

The mitigation (blocking) of the FFR valves was done with 1) surgical tape placed over the valve inside the FFR, 2) electrocardiogram (ECG) pads pressed onto the interior opening of the valve, and 3) placing a surgical mask over the exterior of the FFR.  

NIOSH also tested unregulated face coverings of four models of surgical masks, seven procedure masks, six cloth face coverings, and two fabric masks from cotton t-shirts.  The cloth face coverings, two had filter inserts and three had exhalation valves. I will not report this data because it seems obvious that starting with a poorly-fitting, inferior-filtering cloth mask and adding a valve to make it worse is not worth reviewing.

Conclusions
      Based on a sample size of 13 models, this study found that unmitigated FFRs with an exhalation valve that were tested in an outward position           (with particles traveling in the direction of exhalation) have a wide range of penetration, emitting between <1% and 55%. Further testing could              measure greater particle penetration. 

But in the body of the study it noted a reason some were as low as 1% is that some of the valves did not open during the test.

...those FFRs whose valves did not open may have been designed to open at higher flowrates. The variability within each FFR model could also be explained by how the exhalation valve opens, with some models consistently opening to the same position and other models having variations with the valve even fluttering in the air currents. 

It seems to me that data from these irregularly operating valves only confounds conclusions and should have been separated from general conclusions since one could not, in practice, assume that the valve would be closed during use.  And the valve would be especially likely to open on a cough or sneeze. 

The remaining important conclusion are as follows;

For all models of FFRs, at all flowrates, the best mitigation strategy was to cover the exhalation valve inside the FFR with an ECG pad. With this mitigation, the penetration was below 5% except for one model. Unlike the other FFRs where the tape/ECG pad could make contact with a hard, plastic ring of the valve, the rim of this model was covered with filter media; thereby the adhesive bonded to the fabric and not the plastic, not allowing a complete seal. Securing surgical tape over the exhalation valve inside the FFR performed nearly as well as using the ECG pad. 

This is important since if mitigation with an ECG pad is practiced, it is necessary for hospitals to be well-aware of this model and other similar models in order to avoid purchasing it.

The final conclusions are:

With mitigation measures such as surgical tape or an ECG pad secured inside, the FFRs can perform nearly as well as an FFR with no exhalation valve. 
And
During shortages of respiratory protection, FFRs with an exhalation valve provide an additional source of equipment for workers who need respiratory protection and are concerned about source control

The problem with this is all EEG pads are not the same.  Having had recent experience on a monitor for several days and becoming visibly allergic to one brand, I was plastered with three different brands of EEG pads, each with different degrees of adhesion. One also has to wonder when a mask gets damp inside, would the pad still adhere? 

These uncertainties aside, the good news is there are large supplies of these valved respirators that could be used in an emergency with this mitigation.  And it looks like the study was released just in time for this current one.

Monona

-----Original Message-----
From: John Callen <jbcallen**At_Symbol_Here**GMAIL.COM>
To: DCHAS-L**At_Symbol_Here**Princeton.EDU
Sent: Fri, Dec 11, 2020 11:47 pm
Subject: [DCHAS-L] NIOSH Technical Report P/N 2021-107: Filtering Facepiece Respirators with an Exhalation Valve: Measurements of Filtration Efficiency to Evaluate Their Potential for Source Control

ALL,

The subject study is "hot-off-the-press" and is worthy of your consideration.


This summary has PDF Link so you can read the entire report (attached below).


The Bottom Line : "These finds have important implications for guidance on source control and mitigation."

It maybe possible that this will open up a blocked avenue of RPE.

After review, I certainly welcome your comments.

Be Safe and Stay Healthy!

All My Best and Happy Holidays,

John B. Callen, Ph.D.
3M Personal Safety Division - Retired
ACS/DCHAS Founding Member
(312) 632-0195
--- For more information about the DCHAS-L e-mail list, contact the Divisional membership chair at membership**At_Symbol_Here**dchas.org Follow us on Twitter **At_Symbol_Here**acsdchas
--- For more information about the DCHAS-L e-mail list, contact the Divisional membership chair at membership**At_Symbol_Here**dchas.org Follow us on Twitter **At_Symbol_Here**acsdchas

Previous post   |  Top of Page   |   Next post



The content of this page reflects the personal opinion(s) of the author(s) only, not the American Chemical Society, ILPI, Safety Emporium, or any other party. Use of any information on this page is at the reader's own risk. Unauthorized reproduction of these materials is prohibited. Send questions/comments about the archive to secretary@dchas.org.
The maintenance and hosting of the DCHAS-L archive is provided through the generous support of Safety Emporium.