Date: Mon, 8 Oct 2007 15:11:21 -0500
Reply-To: Diane Amell <Diane.Amell**At_Symbol_Here**STATE.MN.US>
Sender: DCHAS-L Discussion List <DCHAS-L**At_Symbol_Here**LIST.UVM.EDU>
From: Diane Amell <Diane.Amell**At_Symbol_Here**STATE.MN.US>
Subject: Re: laboratory/office environmental control questions
Comments: To: "Peter M. Lazarski"
For "general office areas," federal OSHA recommends the use of ASHRAE
62.1-2004 Ventilation for Acceptable Indoor Air Quality. In Minnesota,
we have a standard, MN Rules 5205.0110 Indoor Workroom Ventilation and
Temperature, which deals with fresh air flow, heat stress, minimum
temperatures and recirculated air. The standard, for those who are
interested, can be found at
http://www.revisor.leg.state.mn.us/bin/getpub.php?pubtype=RULE_CHAP_SEC&year=current§ion=5205.0110
 
- Diane Amell, MNOSHA

>>> "Lazarski, Peter M."  10/8/2007 11:37
AM >>>

NIST has a temperature reference for dimensional calibration

http://ts.nist.gov/WeightsAndMeasures/Publications/gentechlength.cfm

Also, the National Conference for Standardizing Laboratories has a
publication, RP-7, for site selection and design of a metrology
laboratory.

Plagiarizing from "Guidelines for Laboratory Design", J. Wiley & Sons
(1987), p.41, "The temperature in most laboratory buildings does not
require close regulation, that is, no better than +/- 3 F."  This book
also refers to a draft ANSI-ASHRAE ventilation standard 86-62 (1986)
which recommended air exchange rates for public, commercial and
industrial areas. Local building codes were mentioned as sources. 

The CRC Handbook of Laboratory Safety, 5th edition has a large chapter
titled Laboratory Facilities - Design and Equipment.

I think there may be OSHA suggestions for temperatures of general
office
areas.

The information contained in this e-mail message and any attachments
may
be confidential. It is intended only for the use of the individual or
entities named above. If the reader of this message is not the
intended
recipient, you are hereby notified that any dissemination,
distribution
or copying of this communication is strictly prohibited. If you have
received this communication in error, please notify us immediately by
e-mail at the originating address.
Peter Lazarski 
National Grid USA 
Chemical Laboratory, Bldg. 1 
7437 Henry Clay Blvd. 
Liverpool, NY 13088 
(315)460-2114 
-----Original Message-----
From: DCHAS-L Discussion List [mailto:DCHAS-L**At_Symbol_Here**LIST.UVM.EDU] On Behalf
Of
al.muehlhausen**At_Symbol_Here**CIBAVISION.COM
Sent: Monday, October 08, 2007 9:43 AM
To: DCHAS-L**At_Symbol_Here**LIST.UVM.EDU
Subject: [DCHAS-L] laboratory/office environmental control questions

I have been challenged by my engineering group to consider the
following

questions as they pertain to a mixed use office/laboratory building.
Any

input would be useful.

What is the target (set point) temperature, by space type.
What is the acceptable range of temperature, by space type.
What is the response time requirements of the temperature controlling 
system
What is the target (set point) humidity, by space type.
What is the acceptable range of humidity, by space type.
What is the response time requirements of the humidity controlling
system
What is the minimum number of room air changes per hour, by space
type.
What is the maximum number of room air changes per hour, by space
type.
What are the pressure level requirements between / relative to each
space 
type.
What is the response time requirements of the pressure controlling
system.

Kind regards,

Al Muehlhausen
CIBA Vision Corporation
Chemist/Certified Industrial Hygienist
Health, Safety, and Environmental Officer JCE/JCA/BTI
Office 678-415-4217
Cell 678-644-7026

**** For your information: KeySpan is now part of National Grid.**** 

********************************************************************************
This e-mail and any files transmitted with it, are confidential to
National Grid and are intended solely for the use of the individual or
entity to whom they are addressed.  If you have received this e-mail in
error, please reply to this message and let the sender know.

Previous post   |  Top of Page   |   Next post



The content of this page reflects the personal opinion(s) of the author(s) only, not the American Chemical Society, ILPI, Safety Emporium, or any other party. Use of any information on this page is at the reader's own risk. Unauthorized reproduction of these materials is prohibited. Send questions/comments about the archive to secretary@dchas.org.
The maintenance and hosting of the DCHAS-L archive is provided through the generous support of Safety Emporium.