From: George D. McCallion <medchem**At_Symbol_Here**COMCAST.NET>
Subject: Re: [DCHAS-L] Runaway Hot Plates
Date: Tue, 21 Apr 2015 21:58:26 -0400
Reply-To: DCHAS-L <DCHAS-L**At_Symbol_Here**MED.CORNELL.EDU>
Message-ID: 69F2EA07-EBD0-48A0-A74C-A3CF5B6FE69A**At_Symbol_Here**
In-Reply-To <2c05874dfa89441caff680c445b46b17**At_Symbol_Here**>

I cannot recall having a hot plate runaway. Then again, I was accustomed to using IKA Works hot plates.

The Corning ones were pretty good as well.

Dangerous if this occurs, but I would unplug when I was not using them as the power controls can easily be ‰??worn‰?? down due to chemical exposure.



George D. McCallion, CHMT
124 Magnolia Court
Collegeville, PA 19426

Voice: 610.888.2436
Email: medchem**At_Symbol_Here**

‰??If you fail to plan, then you plan to fail"

> On Apr 21, 2015, at 8:20 PM, Pickel, Joseph M. wrote:
> In the past year, we have had a series of issues with "runaway" hot plates. In the first instance, a hot plate in the off position began heating in an unoccupied laboratory resulting in a hood fire. Since then we've observed another hot plate that was heating while in the off position as well as a hot plate that heated uncontrollably while on a low setting. The hot plates that were in use were all relatively new and issues look to be caused by failed circuit boards.
> I presented some of the lessons that we learned from these events at the recent ACS National Meeting and was surprised with how many researchers stopped by my poster to indicate that they have observed the same issues. Descriptions of some of these events and additional details can be found at the following links:
> We're advising our folks to keep hotplates unplugged when not in use and use stirring-only hotplates where possible. In addition, some groups are considering getting rid of their existing hotplates and buying new models, but I fear that these may have the same potential issues. The possibility of installing an on/off switch on the cord has also been discussed, and while this will prevent hot plates from heating while in the off position, it might not help the issue of hot plates running away (uncontrolled) when the hot plate is intentionally turned on.
> I'd like to poll the group- has anyone else had similar issues, and more importantly... what kind of solutions have you identified?
> Thanks,
> Joe Pickel

Previous post   |  Top of Page   |   Next post

The content of this page reflects the personal opinion(s) of the author(s) only, not the American Chemical Society, ILPI, Safety Emporium, or any other party. Use of any information on this page is at the reader's own risk. Unauthorized reproduction of these materials is prohibited. Send questions/comments about the archive to
The maintenance and hosting of the DCHAS-L archive is provided through the generous support of Safety Emporium.