From: Monona Rossol <0000030664c37427-dmarc-request**At_Symbol_Here**LISTS.PRINCETON.EDU>
Subject: Re: [DCHAS-L] What should be in an IH report?
Date: Wed, 15 Feb 2017 14:10:26 -0500
Reply-To: ACS Division of Chemical Health and Safety <DCHAS-L**At_Symbol_Here**PRINCETON.EDU>
Message-ID: 15a432ed370-764f-ce66**At_Symbol_Here**webprd-m22.mail.aol.com
In-Reply-To


Good points, but I can clear up one point about what defines lead paint.


The AIHA defines it (in several publications including a power point) as paint containing 1.0 mg/cm2 = 0.5% by weight.  They are using the HUD definition for Evaluation of Lead-based Paint Hazards in Housing.  And that's the number I see on most good reports.

However, I'm also aware that 16 CFR 1303 defines it as 0.05% by weight.  This rule is enforced by the US Consumer Product Safety Commission.  And there is a separate standard now for children's painted articles of 1 ppm after the passage of the CPS Improvement Act (CPSIA).

So for workers, I'm happy with the 0.5% standard in paint that would not be disturbed.  But abatement workers need protection such as working wet or PPE with 0.5% paint dusts.  That's 50.000 ppm in the dust.


Monona Rossol, M.S., M.F.A., Industrial Hygienist
President:  Arts, Crafts & Theater Safety, Inc.
Safety Officer: Local USA829, IATSE
181 Thompson St., #23
New York, NY 10012     212-777-0062
actsnyc**At_Symbol_Here**cs.com   www.artscraftstheatersafety.org

 


-----Original Message-----
From: Frazier, Alicia S <Alicia.S.Frazier**At_Symbol_Here**TSOCORP.COM>
To: DCHAS-L <DCHAS-L**At_Symbol_Here**PRINCETON.EDU>
Sent: Wed, Feb 15, 2017 11:39 am
Subject: Re: [DCHAS-L] What should be in an IH report?

Technically unless the facility being inspected is covered by AHERA or a state has laws regulating asbestos reports there are no regulations regarding what is in a report. However, most good consultants will follow AHERA guidance or a slightly modified version when preparing reports on asbestos because that is what we are used to seeing.

Lead is more complicated in that nobody agrees on how lead containing material is defined. And to my knowledge there are no formats on how reports should come in. If they are personnel samples, lead in air, the information should come like any other IH personnel sample report. But for bulk lead samples, my ask has been: Very good description of where the sample was taken, photograph if possible; chain of custody and lab report; I specify ICP for analysis.


Alicia Frazier  | 19100 Ridgewood Parkway | Tesoro Companies, Inc.| San Antonio, TX  78259
Direct: 210-626-6615 | Mobile: 210-412-3253  | Alicia.S.Frazier**At_Symbol_Here**tsocorp.com

-----Original Message-----
From: ACS Division of Chemical Health and Safety [mailto:DCHAS-L**At_Symbol_Here**PRINCETON.EDU] On Behalf Of Secretary, ACS Division of Chemical Health and Safety
Sent: Wednesday, February 15, 2017 6:52 AM
To: DCHAS-L**At_Symbol_Here**PRINCETON.EDU
Subject: [DCHAS-L] What should be in an IH report?

From: Monona Rossol <actsnyc**At_Symbol_Here**cs.com>
Re: What should be in an IH report?

I'd like to start a new thread by asking for help on a subject that has me stymied.

I've been looking at asbestos and lead paint inspection and some are great and other are appalling. The appalling ones don't identify the sampling equipment and methods, don't identify the data units and standards in their charts, don't tell you where the samples were taken from and when (good ones provide pictures and maps), don't provide copies of chain of custody documents, the contractors certifications and more.

I have crawled all over the net and the AIHA site looking for minimum specifications for data to be reported on these various types of reports. NADA. There MUST be some kinds of minimum standards. I did find one set of Wisconsin state regulations that required some of this information, but that's it.

Can anyone provide a list of what these contractors should be required to provide in their reports?

Monona Rossol, M.S., M.F.A., Industrial Hygienist
President: Arts, Crafts & Theater Safety, Inc.
Safety Officer: Local USA829, IATSE
181 Thompson St., #23
New York, NY 10012 212-777-0062
actsnyc**At_Symbol_Here**cs.com www.artscraftstheatersafety.org


Ralph Stuart
secretary**At_Symbol_Here**dchas.org
Secretary
Division of Chemical Health and Safety
American Chemical Society

---
This e-mail is from DCHAS-L, the e-mail list of the ACS Division of Chemical Health and Safety.
For more information about the list, contact the Divisional secretary at secretary**At_Symbol_Here**dchas.org

---
This e-mail is from DCHAS-L, the e-mail list of the ACS Division of Chemical Health and Safety.
For more information about the list, contact the Divisional secretary at secretary**At_Symbol_Here**dchas.org
--- This e-mail is from DCHAS-L, the e-mail list of the ACS Division of Chemical Health and Safety. For more information about the list, contact the Divisional secretary at secretary**At_Symbol_Here**dchas.org

Previous post   |  Top of Page   |   Next post



The content of this page reflects the personal opinion(s) of the author(s) only, not the American Chemical Society, ILPI, Safety Emporium, or any other party. Use of any information on this page is at the reader's own risk. Unauthorized reproduction of these materials is prohibited. Send questions/comments about the archive to secretary@dchas.org.
The maintenance and hosting of the DCHAS-L archive is provided through the generous support of Safety Emporium.