DCHAS-L Discussion List Archive
Date: Tue, 17 Nov 2009 09:30:18 -0500
Reply-To: DCHAS-L Discussion List <DCHAS-L**At_Symbol_Here**LIST.UVM.EDU>
Sender: DCHAS-L Discussion List <DCHAS-L**At_Symbol_Here**LIST.UVM.EDU>
From: ILPI <info**At_Symbol_Here**ILPI.COM>
Subject: Re: Tool selection for removing hoses from glassware
In-Reply-To: <FE0292FE-C278-4EB2-9B94-2E3EBE044854**At_Symbol_Here**ilpi.com>
Two items to follow up
here:
2. I should have mentioned that a competent
glassblower can easily convert existing barb connections to GL-14
connections like those I referenced below. As always, be sure the
glassware is scrupulously clean before giving it to your
glassblower!
Rob
Toreki
On Nov 10, 2009, at 1:08 PM,
ILPI wrote:
Disclaimer: I'm the
owner of Safety Emporium.
Best
wishes,
Rob Toreki
On Nov
10, 2009, at 12:16 PM, Jeskie, Kimberly B. wrote:
We=92ve been looking hard at
our hand injuries lately and are focusing on cutting tool and glove
selection. One thing in particular that we haven=92t been able to
come up with a good solution for is a tool that works well for removing
tubing that has basically seized or =93become one with=94 the glass
connections on condensers, cold fingers, etc. I=92m sure you=92ve
seen this before and most people reach for their pocket knife or a razor
blade. It generally ends badly. Either the blade slips or
the glass breaks and in either situation we end up with stitches.
Anyone found a tool that works better under these
conditions?
Kim
Kimberly
Begley Jeskie, MPH-OSHM
Operations Manager
Physical Sciences Directorate
Oak
Ridge National Laboratory
(865)
574-4945
=======================================================
Safety Emporium - Lab & Safety Supplies featuring brand
names
Previous post | Top of Page | Next post
