From: ILPI Support <info**At_Symbol_Here**>
Subject: Re: [DCHAS-L] Options to replace oil baths for heating
Date: Tue, 12 May 2015 16:24:48 -0400
Reply-To: DCHAS-L <DCHAS-L**At_Symbol_Here**MED.CORNELL.EDU>
Message-ID: 98A3A5AC-5743-45E8-A50C-34BBA7860E97**At_Symbol_Here**

See , in particular the section on Eutectic salt mixtures.

I'll be updating that page at some point in the next couple months to cover heating blocks

Rob Toreki

Safety Emporium - Lab & Safety Supplies featuring brand names
you know and trust.  Visit us at
esales**At_Symbol_Here**  or toll-free: (866) 326-5412
Fax: (856) 553-6154, PO Box 1003, Blackwood, NJ 08012

On May 12, 2015, at 11:51 AM, Debbie M. Decker <dmdecker**At_Symbol_Here**UCDAVIS.EDU> wrote:

Good morning:
I need to offer some options to replace oil (silicone or mineral) with a different material for heating baths.  I'm also looking at heating block options and have a number of suppliers to review - cost may be an issue here.
Ideas?   The Google has failed me this morning.
Debbie M. Decker, CCHO, ACS Fellow
Safety Manager
Department of Chemistry
University of California, Davis
122 Chemistry
1 Shields Ave.
Davis, CA  95616
Birkett's hypothesis: "Any chemical reaction
that proceeds smoothly under normal conditions,
can proceed violently in the presence of an idiot."

Previous post   |  Top of Page   |   Next post

The content of this page reflects the personal opinion(s) of the author(s) only, not the American Chemical Society, ILPI, Safety Emporium, or any other party. Use of any information on this page is at the reader's own risk. Unauthorized reproduction of these materials is prohibited. Send questions/comments about the archive to
The maintenance and hosting of the DCHAS-L archive is provided through the generous support of Safety Emporium.